Category: Elegoo Saturn

3D printed Prinz Eugen model

August 31, 2023

After completing my 1.5 year long magnum opus called Charles Martel, I wasn’t ready for another long term commitment but I did want to putter around with something…
I remembered the 1/500 scale WWII German recognition models made by Comet and thought they’d be perfect. Here is the first: Prinz Eugen.
I also wanted to fire up the Ender 3 again and thought it would be a good fit for the “Wooden” hull parts. I used my Elegoo Saturn for the parts that would have been cast lead on the Comet models.
She’s not a perfect replica – I made some minor improvements and a couple mistakes but at less then a month from design to done – close enough!

This was a small, simple build, so no project page, just this post.

Update Aug. 15, 2025

I just finished recreating the entire USN WWII German Naval Recognition Set (and then some) in 1/500 scale, check out the results.

Charles Martel French Battleship, 3D printed with an Elegoo Saturn

This post introduces the Charles Martel project page. The Charles Martel was a French pre-dreadnought battleship from the end of the 19th century. Her 1/200 scale model has been by far my most ambitious 3D build, taking over a year and a half from Blender design to display case. Her project page has a ton of Elegoo Saturn print example shots, in-progress build pictures, and comments from the assembly process, below are a few images from it.

My First Elegoo Saturn Project

Elegoo Saturn 3D print project USS Tigrone
Elegoo Saturn 3D print project USS Tigrone, partial print fail

It was a long time coming but I finally completed my first large, resin only project, using my new Elegoo Saturn 3D printer. Follow the link to USS Tigrone‘s project page for details and lots of print and build pictures.

Update: To see my most ambitious Elegoo Saturn project, check out Charles Martel