Posted: 12/21/2020
Printing for this project went smoothly, even though the LD-002r bits were printed in my unheated shed with temps in the mid to upper 30s. The turret shown is my 3rd printed – due to poor designs on my part and no fault of the printer. The first just looked too fat and the second one’s rear extension was all wrong. As I mentioned in an earlier post much of the hull assembly is already done so, initial build pictures may be up before Christmas.
Update: 1/1/2021
My m26 Pershing is now complete, visit the new project page for more details and the finished model pictures.